Geobulletin alpha

News from the Geoblogosphere feed

by Stratigraphy.net
New from Snet: Lithologs, a new tool to create lithological/sedimentological logs online..

Blog post recommendation

Origin of the Moon--redux!

Ever since Harold Urey proposed his theory for the origin of the Moon in 1952, it's origin has been the topic of debate, a debate that has not yet been settled.  One of the goals of the manned space program to the Moon was to get samples that would solve this debate but, because the Moon has undergone differentiation and a complicated geological history, we know a lot about the evolution of the Moon, but not about its origin.  In Nature Geoscience (v. 10, pp. 89-94, 2017) Rufu, Aharonson and Perets advance a theory that the Moon was formed, not by a single impact of a Mars-sized planetesimal as in the current paradigm, but by a series of smaller impacts.
     Some of the constraints that must be satisfied by a theory of origin are as follows.  The Moon is massive relative to its planet compared to Moons around other bodies in the Solar System.  The Earth-Moon system exhibits an unusually large amount of angular momentum. The Moon is depleted in volatile elements compared to carbonaceous chondrites which are taken as representative of undifferentiated planetary material.  This depletion is taken to indicate that some highly energetic process heated the moon. In contrast, rarefactory elements, such as Ca, Al, Ti, Ba, Sr,..., are enhanced. Iron is depleted relative to its abundance in the earth. The oxygen isotope compositions for the earth and Moon are similar, a fact that suggests that they were formed from the same material and their relative values compared to other bodies in the Solar System suggests that they were formed in the same vicinity.
     A major problem with single-impact scenarios is that a single impact cannot provide the observed angular momentum.  Rufu et al. argue that the largest impactor is also not necessarily the last one, and that multiple impacts are needed to provide both the observed angular momentum and observed mass. 
     Rufu et al. point out that computer simulations of impacts show that the projectile contributes more than 70% the the mass of the Earth-orbiting disk in which the ejecta land to later accrete into a single Moon. This so-called "skewed mass" contribution of the impactor is a problem because it is unlikely that the impactor and the proto-earth would have the same composition.  How can the Earth and Moon be isotopically similar in oxygen, titanium, tungsten?? In the multi-impact scenario proposed by these authors the proto-Earth experiences a number of collisions by bodies ranging in mass from 0.01 to 0.1 times the mass of the proto-Earth as shown in this figure from the paper:


Multi-impact scenario for      Figure caption: Each impact by one of the small bodies generates a disk of material from which a small satellite forms.  These small satellites migrate outward under the influence of tidal interactions, and end up at their "Hill radii" to eventually coalesce to form the final Moon. The Hill radius for the Earth is the region in which the Earth dominates the attraction of satellites. 
    
Using computer simulations of multiple impacts in which parameters for the impactor mass ratio, speed, direction angle, and planetary rotation were varied, they examined whether or not the earth gained or lost material due to the impact. They found that lower impact angles favored planetary erosion over planetary accretion for the earth. They also found that it was difficult to make a Moon of the current mass from an impact, and that it was easier to create a number of sub-lunar mass disks sequentially, from which the Moon formed by the merger of multiple moonlets as shown in the figure.








    

Stratigraphy.net | Impressum
Ads: